dongguan kailong machinery co

How to use the electric vehicle backrest, seat and foot pad embossing and creasing machine
Check that the cleaning control switch of the machine is in the closed position, adjust the time to the maximum, and then turn on the power switch. At this time, the power indicator light is on, and the electronic tube cooling fan is running. Warm up the tubes for minutes.
Install the mold, close the high-cycle switch and automatic manual switch on the control panel, then move the up and down buttons to the appropriate position, and install the mold on the upper electrode aluminum plate.
Place an aluminum plate on the sliding table and lay the insulating material flat on the aluminum plate.
Adjust the harmonizer in place and place the sample on the insulating material of the slide table. Push the slide table into the press. The machine head will automatically lower and compact. Then adjust the parallel screws of the balance plate to combine the mold with the table.
Adjust the time relay drop time on the control panel to set the press to the bottom and then delay for about seconds to exit the high cycle. The setting time can be set in seconds. The rising time setting is adjusted until the press bed lifts the mold and bottom plate. The welding time should be flexibly adjusted according to the actual situation.
Set the welding time for about 2 seconds and then turn on the high-cycle switch. The AC contactor pulls in the high-cycle working ammeter and the product starts to heat seal. Automatically cut off the high pressure setting and rise after seconds. Pull out the slide table and take out the workpiece to check the heat sealing effect. The heat sealing effect is related to the position of the mold pressure and heat sealing time synchronizer, which can be flexibly adjusted for different materials.
This machine can be used by two people alternately but cannot be used at the same time
When stopping working, the power should be turned off and the main switch cut off
The purpose of the electric vehicle backrest, seat cushion and foot pad embossing and creasing machine Flower motorcycle seat cushion embossing electric vehicle foot mat embossing car seat cushion cover embossing leather seat cover embossing machine plastic foot mat embossing electric vehicle back cushion embossing tricycle seat cushion embossing machine advertising floor mat embossing, etc.